Below is a painting guide, explaining the steps taken to paint Ironhelm Fortress. The model was initially primed with matt black primer. Stone This is the scheme used for the bricks and stone. Heavy dry-brush: Army Painter Dungeon Grey. Lighter dry-brush: Army Painter Ash Grey. Final highlight: Army Painter Arid Earth. Trim This is the… Read more
Below is a painting guide, explaining the steps taken to paint The Temple of the Damned. The model was initially primed with matt black primer. Bone This is the scheme used for the skulls, bone edging and teeth on the roof. Heavy dry-brush: Army Painter Leather Brown. Lighter dry-brush: Army Painter Barbarian Flesh. Wash:… Read more
Below are the scale reference guides for the models showing their sizes in relation to other models in their corresponding ranges. Dwarven scale reference Elven scale reference Demon scale reference
This is a video showing some different ways to configure the Elven Groves OpenLOCK scatter terrain. There are 16 pieces in this set. Included are 5 corner end pieces, as well as 1″, 2″, 4″ and 6″ length walls, and a 3″ doorway that grant a wide variety of wall configurations. There are also… Read more
This is a video showing some different ways to configure the Caverns of Torment OpenLOCK scatter terrain. There are 14 pieces in this set. Included are 5 corner end pieces, 1″, 2″, 4″ and 5″ length walls, as well as 45- and 90-degree curves. There are also S curve pieces to make “snakelike” walls…. Read more
Here is the list of parts required (per level) to create the Large Square Tower.
This is the list of parts required (per level) to build the Round Tower with Buttress.
A step by step guide to painting the wooden floors Use a paint brush and paint colours = oak brown, monster brown, true copper. (Any dark brown and light brown combination will work) 2. Wooden floors primed and ready to paint. 3. Firstly start with the black primed wooden floor tile, secondly paint a base coat… Read more
OpenLOCK parts print with small supports in front of the OpenLOCK ports. Remove the supports so you can insert the OpenLOCK. Use a pair of pliers to remove the supports. Be careful not to break the dividers between the OpenLOCK ports. Save Save Save Save
OpenLOCK is an open-source building system that allows miniature scenery designers to design amazing cross-compatible scenery for tabletop games. The system uses OpenLOCK clips to fasten the pieces in place, and top locking pins to allow building levels to be stacked. The complete set of OpenLOCK templates are freely available for download, which means that… Read more