SuperJim

[SuperJim]

Looks like it was a temporary thing, both were released in the latest update.

[SuperJim]

I’ve done the cottage, homestead, barracks and tower, and most of the chieftain’s hall (just the dungeon base left). They are printed at 0.16mm layer height, 5% infill, 3 perimeters, 4 top / bottom layers.

Attachments:

1. 

   IMG_3489x.jpg
   

2. 

   IMG_3490x.jpg
   

3. 

   IMG_3475x.jpg
   

4. 

   IMG_3496x.jpg
   

[SuperJim]

The new longhouse model appears to have a larger design of the pins, with chamfered edges.

[SuperJim]

Used for loading a wagon perhaps, or to access the roof.

[SuperJim]

I’m printing the homestead roof @ 100%. It requires supports for several overhangs, and they have provided a pre-supported version (which I am using). I’ve attached a photo of the print in progress, and you can see the supports (which are broken).

Attachments:

1. 

   progress.jpg
   

[SuperJim]

I’ve been thinking about this, on the one hand you have infill, but with the alternative you would have a complete inner perimeter, which might use even more plastic. I have the homestead roof printing atm, and it’s going to take about 30 hours. Unfortunately the provided supports are too weak and have mostly snapped off (not from the bed; snapped half way up) so I’m not sure how good the quality will be.

[SuperJim]

This is the cottage at 0.16mm. Unfortunately had to reduce size due to 2mb limit.

Attachments:

1. 

   83F9D41C-2221-4663-BB71-5BAAECDD6E08.jpeg
   

[SuperJim]

Was this fixed in v1.4? I downloaded before this thread, but don’t seem to have the issue.

[Author]

Posts