Cart (0)

Jacob Nichols

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Ender 3 hanging strings #195959
    AvatarJacob Nichols
    Participant

    Oh.. well thats nice! Good to know you guys are on it. I checked my settings, totally within normal temperature. In fact, I set this next build on the lower setting to see if it could prevent some of the sag. Would you guys suggest printing with some sort of supports? Like tree supports? Or are these models made to be print stand alone without supports? I bought your whole ruined collection and want to buy the other 2 fantasy collections, but want to get this sorted before I do. Thanks!

    in reply to: Ender 3 hanging strings #195935
    AvatarJacob Nichols
    Participant

    Using the Hatchbox filament off Amazon. Is there a way to change the temperature default when printing? Is that done in Cura or on the printer itself? Is there a temp that is noticeably too low? Any suggestions for assisting?

Viewing 2 posts - 1 through 2 (of 2 total)
©2021 Printable Scenery. Website by Vienna & Bailey