Cart (0)

MJJEPPER

Forum Replies Created

Viewing 12 posts - 1 through 12 (of 12 total)
  • Author
    Posts
  • in reply to: Different Nozzle sizes? #263081
    AvatarMJJEPPER
    Participant

    I use only 0.3 mm at 0.12 mm layer height now. It is worth the longer prints.

    in reply to: BA-AS-Wall for other sets #263078
    AvatarMJJEPPER
    Participant

    And DS walls too!

    in reply to: Trollskull Manor & Inn #263077
    AvatarMJJEPPER
    Participant

    Sdollins, those beers… how? Clear resin 3d printing? They look great!

    in reply to: Schist walls D section #263074
    AvatarMJJEPPER
    Participant

    Bump! I would also say the D corbel schist window needs some love too. The window top is terrible!

    in reply to: Inn of the Welcome Wench #263073
    AvatarMJJEPPER
    Participant

    I am still printing this one. Did you ever figure it out?

    in reply to: Ruins for Stone Floor #262348
    AvatarMJJEPPER
    Participant

    I echo Nathaniel’s concern. The rough stone set could use some help. While we can print rough stone floors, many of the other pieces are for the smooth stone floors. Also, many of heavy stone options are not yet updated to remove overhangs. The latter is something I need before I would print these pieces. Hopefully after shadowfey, they can come back and take a look at these sets.

    in reply to: Column with three side connections #262088
    AvatarMJJEPPER
    Participant

    An X or T junction would be great. I plan to glue in magnetic clips anyways. If I have to print a bit less clip to fit 8 of them into an X column… so be it!

    in reply to: Inn of the Welcome Wench #239353
    AvatarMJJEPPER
    Participant

    Hey Brian,
    What layer height do you use. That is a lot of printed pieces!

    in reply to: But when is a nice Cyberpunk theme? #238691
    AvatarMJJEPPER
    Participant

    Gentlemanbear, agreed. Also, it is even worse with 3d printable miniature models. Everything is so over the top.

    in reply to: Phrozon Sonic Mini #238559
    AvatarMJJEPPER
    Participant

    I have been using a any cubic photon for very detailed parts and two ender 5s for routine terrain prints. I end up dry brushing resin and curing it for the ender prints to get rid of layer lines. Both options seem to work well.
    I have been thinking of getting a 4 K as I downscale all of my minis… So the extra resolution I would assume would help. Anyways, let me know how your experience is. I am curious.

    in reply to: Rampage Complete Dungeons – Pledge? #237614
    AvatarMJJEPPER
    Participant

    Thank you Jebson for your replies. When approximately will the pledge system be back up? Also, has your team announced what the new kickstarter is for? I couldn’t find it. Neither here nor on Kickstarter.

    in reply to: Rampage Complete Dungeons – Pledge? #237297
    AvatarMJJEPPER
    Participant

    Awesome news. Previously, due to the overhang issues I was not interested; however, with the fixes to the basic starter set, I am getting pristine prints! Excited to print this set now.

Viewing 12 posts - 1 through 12 (of 12 total)
©2021 Printable Scenery. Website by Vienna & Bailey