Cart (0)

davidlmosely

Forum Replies Created

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • in reply to: Mashups #172915
    Avatardavidlmosely
    Participant

    Ok, I was just worried about ending up with holes or gaps, or it trying to print the pieces as still separate. Or throwing off the fit when used with modular pieces.

    in reply to: Preview of redone Water Mill and Merchants and Market #149124
    Avatardavidlmosely
    Participant

    Sweet! I’m working my way through all the ruined buildings right now and then planning on doing the complete ones. I just think it would be cool to pay a game where everything starts out new but ends up in ruins lol

    in reply to: Preview of redone Water Mill and Merchants and Market #148907
    Avatardavidlmosely
    Participant

    Very cool! Are these being redone to bring up to current standards or part of something larger?

    in reply to: Ruined Porthouse #148544
    Avatardavidlmosely
    Participant

    The wasn’t much of a process lol. I blocked out all the main colors with the airbrush and then used it to had two layers of highlights to the roof. Everything else was brush, dry brush and wash. I followed this guide: https://youtu.be/oSqbT0HO74U
    I just matched the paint colors as best I could with cheap craft paints.

    Side note: That video was how I found out about printable scenery and 3D printing. I was sold immediately lol

    in reply to: It begins! #144297
    Avatardavidlmosely
    Participant

    Wow! That looks amazing in resin!

    in reply to: Working towards a siege #140677
    Avatardavidlmosely
    Participant

    That’s an awesome setup!

    in reply to: Loving the Sewer Tiles #140675
    Avatardavidlmosely
    Participant

    Those look great!

    in reply to: Demon Buildings #140200
    Avatardavidlmosely
    Participant

    WOW, those look great!

    in reply to: Ruined Tribal Fort tusks #140187
    Avatardavidlmosely
    Participant

    Looks like slowing down did the trick! I dropped the overall print speed to 40mm/s and everything looks to be working perfect, my surface quality went way up too. It really didn’t add much time to the print either, maybe a couple minutes on a one hour print. Also for anyone using the CR-10S Pro, flashing the tinymachines firmware is a must I found out. I was having fits getting the bed leveled and now the printer works just how I hoped it would. Thanks for the help!

    in reply to: Code of Conduct #138061
    Avatardavidlmosely
    Participant

    Hello from Texas! just bought my first 3D printer and both the D.E.A.D. and Lost Islands complete sets, can’t wait to get started!

Viewing 10 posts - 1 through 10 (of 10 total)
©2020 Printable Scenery. Website by Vienna & Bailey